Filter
Top Products
ASUS RS100-E5-PI2 6-3
6.1.2 Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance,
install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID conguration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
6.1.3 Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Main menu, select IDEConguration, then press <Enter>.
3. Select the item CongureSATAAs, then press <Enter> to display the
conguration options.
4. Select RAID from the CongureSATAAs item options, then press <Enter>.
5. Save your changes, then exit the BIOS Setup.
Refer to Chapter 5 for details on entering and navigating through the BIOS
Setup.
6.1.4 RAIDcongurationutility
Depending on the RAID_SEL1 jumper setting and the operating system, you can
select a utility to create a RAID set. Refer to section 4.2 Jumpers for details on the
RAID_SEL1 jumper settings.
Use the Intel
®
Matrix Storage Manager to create a RAID 0 or RAID 1 set under
Windows
®
Server operating system.
Use the LSI Software RAID Conguration Utility to create a RAID 0 or RAID 1
under Windows
®
Server or Red Hat
®
Enterprise operating system.
Refer to the succeeding sections for details on how to use the RAID conguration
utilities.