Filter
Top Products
Version 6.2 107 December 2010
SIP Release Notes 1. What's New in Release 6.2
Parameter Description
Flash Keys Sequence Style
[FlashKeysSequenceStyle
]
Modification: Option [2] added (MP-1xx, Mediant 600, Mediant 800
MSBG, Mediant 1000 MSBG, Mediant 1000).
Hook flash keys sequence style.
[0] 0 = Flash hook (default) - only the phone's Flash button is used,
according to the following scenarios:
During an existing call, if the user presses Flash, the call is put
on hold; a dial tone is heard and the user is able to initiate a
second call. Once the second call is established, on-hooking
transfers the first (held) call to the second call.
During an existing call, if a call comes in (call waiting), pressing
Flash places the active call on hold and answers the waiting
call; pressing Flash again toggles between these two calls.
[1] 1 = Sequence of Flash Hook and digit:
Flash + 1: holds a call or toggles between two existing calls
Flash + 2: makes a call transfer.
Flash + 3: makes a three-way conference call (if the Three-
Way Conference feature is enabled, i.e., the parameter
Enable3WayConference is set to 1 and the parameter
3WayConferenceMode is set to 2).
[2] 2 = Sequence of Flash Hook and digit:
Flash Hook only: places a call on hold.
Flash + 2: places a call on hold and answers a call-waiting call,
or toggles between active and on-hold calls.
Flash + 3: makes a three-way conference call (if the parameter
Enable3WayConference is set to 1 and the parameter
3WayConferenceMode is set to 2). Note that the settings of the
ConferenceCode parameter are ignored.
Flash + 4: makes a call transfer.
3-Way Conference Mode
[3WayConferenceMode]
Modification: Option [2] On-Board added (Mediant 800 MSBG,
Mediant 1000 MSBG, Mediant 1000).
Defines the mode of operation when the 3-Way Conference feature is
used.
[0] AudioCodes Media Server = The Conference-initiating INVITE
(sent by the device) uses the ConferenceID concatenated with a
unique identifier as the Request-URI. This same Request-URI is set
as the Refer-To header value in the REFER messages that are sent
to the two remote parties. This conference mode is used when
operating with AudioCodes IPMedia conferencing server. (Default)
[1] Non-AudioCodes Media Server = The Conference-initiating
INVITE (sent by the device) uses only the ConferenceID as the
Request-URI. The conference server sets the Contact header of the
200 OK response to the actual unique identifier (Conference URI) to
be used by the participants. This Conference URI is then included
(by the device) in the Refer-To header value in the REFER
messages sent by the device to the remote parties. The remote
parties join the conference by sending INVITE messages to the
conference using this conference URI.
[2] On Board = On-board 3-way conference. The conference is
established on the device without the need for an external
Conference server. The device sets up the call conference using its
IP media channels. These channels are obtained from the IP media
module (i.e., MPM module). Note that the MPM module(s) must be
installed to support three-way conferencing. You can limit the