Filter
Top Products
28 CPS Installer/User Guide
command may be used to override the Server CLI access character on a
per-port basis. For more information, see Server CLI command and Port Set
command in Chapter 5.
To display CLI access character information:
Issue a Show Server CLI command.
SHOW SERVER CLI
For more information, see Show Server CLI command in Chapter 5.
Ending device sessions
To end your CPS session:
Enter CLI mode and issue a Quit command or a User Logout command.
QUIT
- or -
If you initiated the device session with a Connect command, enter CLI mode
and issue a Disconnect command.
DISCONNECT
- or -
Allow the port to time-out due to inactivity. In this case, a notification message
is issued and the serial CLI session returns to CLI mode. This time-out may
occur while you are in CLI mode.
- or -
For modem connections, if a carrier drop occurs, the serial CLI session is
automatically logged off.
To end another user’s CPS session:
Issue a User Logout command.
USER LOGOUT <username>
A message is sent and the Telnet or SSH connection is dropped. For more
information, see User Logout command, Disconnect Command, and Quit
Command in Chapter 5. For information about preempting a user’s session,
see Preemption in this chapter.
Managing User Accounts
The CPS user database can store information for up to 64 user accounts.