Filter
Top Products
64 CPS Installer/User Guide
Server PPP Command Parameters (Continued)
Parameter Description
REMOTEIP=<rem_ip> IP address to assign to the PPP client end of the PPP connection.
Must be on same subnet as LOCALIP address.
MASK=<subnet> LAN subnet for the PPP dial-in client.
Examples
The following command enables the PPP server with a local IP address
of 192.168.0.1, a remote IP address of 192.168.0.2 and a subnet mask of
255.255.255.0.
> ser ppp ena loc=192.168.0.1 rem=192.168.0.2 mas=255.255.255.0
The following command enables the PPP server with previously-configured IP
and subnet mask values. This form of the command would not be valid unless
the IP and subnet mask values had been previously configured.
> server ppp enable
Server RADIUS command
The Server RADIUS command defines or deletes RADIUS parameters for
the CPS RADIUS client. For more information, see RADIUS authentication in
Chapter 3.
When you enter this command, you are asked to confirm or cancel the
specified changes.
Access right: SCON; Access level: AA
Syntax
SERVER RADIUS PRIMARY|SECONDARY
IP=<radius_ip> SECRET=<secret> USER-RIGHTS=<attr>
[AUTHPORT=<udp>] [TIMEOUT=<time-out>] [RETRIES=<retry>]
- or -
SERVER RADIUS PRIMARY|SECONDARY DELETE
Server RADIUS Command Parameters
Parameter Description
PRIMARY Indicates the primary RADIUS server is being defi ned or deleted.
SECONDARY Indicates the secondary RADIUS server is being defi ned or deleted.
IP=<radius_ip> IP address of the RADIUS authentication server.
SECRET=<secret> 8-24 character text string for shared secret with the RADIUS server.
Enclose the string in quotes if it contains spaces.