Filter
Top Products
Chapter 5: CPS Commands 65
Server RADIUS Command Parameters (Continued)
Parameter Description
USER-RIGHTS=<attr> Attribute number defi ned on the RADIUS server, in the range 1-255.
AUTHPORT=<udp> UDP port for RADIUS authentication server, in the range 1-65535.
This value is usually 1645, but may be 1812.
Default = 1645
TIMEOUT=<time-out> Number of seconds to wait for a response from the RADIUS server,
in the range 1-60.
Default = 5
RETRIES = <retry> Number of attempts to make to authenticate a user after a time-out,
in the range 1-10.
Default = 3
DELETE Deletes the RADIUS server defi nition.
Examples
The following command specifies primary RADIUS server information; default
values will be used for the UDP port, time-out and retries values.
> ser radius primary ip=192.168.0.200 secret=ThePrimaryRadSecret
user-rights=86
The following command deletes the primary RADIUS server definition.
> ser radius primary del
Server Reboot command
The Server Reboot command reboots the CPS. During a reboot, any active
Telnet sessions, including your own, are terminated, and all users are
informed accordingly. Any CPS configuration changes that require a reboot
will become effective when the reboot completes.
When you enter this command, you are asked to confirm or cancel the reboot.
Access right: SCON; Access level: AA
Syntax
SERVER REBOOT
Server Security command
The Server Security command specifies the authentication mode, encryption
level and security lock-out. For more information, see Using Authentication
and Encryption and Using Security Lock-out in Chapter 3.
When you enter this command, you are asked to confirm or cancel the
specified information.