Filter
Top Products
73
Troubleshooting
73
section
2
1
3
4
5
6
7
8
9
10
12
type in “ISP”.
If you are still unable to access the Internet after verifying these
settings, please contact Belkin Technical Support.
Problem:
• The Setup Assistant completed, but my web browser doesn’t work.
• I am unable to connect to the Internet. The “ADSL” LED on my
Router is blinking, and the “Internet” LED is solid.
Solution:
1. If the “ADSL” LED is blinking, and the “Internet” LED is solid,
but you are unable to access the Internet, there may be third-
party firewall software installed on the computer attempting to
access the Internet. Examples of third-party firewall software are
ZoneAlarm, BlackICE PC Protection, McAfee Personal Firewall,
and Norton Personal Firewall.
2. If you do have firewall software installed on your computer,
please make sure that you properly configure it. You can
determine if the firewall software is preventing Internet access
by temporarily turning it off. If, while the firewall is disabled,
Internet access works properly, you will need to change the
firewall settings to function properly when it is turned on.
3. Please refer to the instructions provided by the publisher of your
firewall software for instructions on configuring the firewall to
allow Internet access.
If you are still unable to access the Internet after disabling any
firewall software, please contact Belkin Technical Support.
Problem:
I can’t connect to the Internet wirelessly.
Solution:
If you are unable to connect to the Internet from a wireless
computer, please check the following items:
1. Look at the lights on your Router. If you’re using a Belkin Router,
the lights should be as follows:
• The “Power” LED should be on.
• The “ADSL” LED should be on, and not blinking.
• The “Internet” LED should be on, and not blinking.