Billion Electric Company 30 Network Card User Manual


 
59
ISP setting in WAN site:
Obtain an IP Address automatically (DHCP Client)
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
End IP Address: 192.168.1.199
3.5.1 User Name and Password
The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your BiGuard
30 to its factory settings by holding the Reset button on the back of your router until
the Status LED begins to blink. Please note that doing this will also erase any
previous router settings that you have made. The Status LED will remain solid as the
device boots. Once the boot sequence is complete, the LED will shut off, indicating
that BiGuard 30 is ready.
3.5.2 LAN and WAN Port Addresses
The default values for LAN and WAN ports are shown below:
LAN Port WAN Port
IP address
192.168.1.254
Subnet Mask
255.255.255.0
DHCP server
function
Enabled
IP addresses for
distribution to
PCs
100 IP addresses continuing
from 192.168.1.100 through
192.168.1.199
The DHCP Client is enabled to
automatically get the WAN port
configuration from the ISP.
3.6 Information From Your ISP
3.6.1 Protocols