Filter
Top Products
48 en | Configuration Using a Web Browser VideoJet X10
DOC | V4.0 | 2009.06 Installation and Operating Manual Bosch Security Systems
– High resolution (4CIF/D1)
High resolution for high bandwidth connections, resolution 704 × 576/480 pixels
– DSL
For DSL connections with 500 kbps, resolution 352 × 288/240 pixels
– ISDN (2B)
For ISDN connections via two B-channels, resolution 352 × 288/240 pixels
– ISDN (1B)
For ISDN connections via one B-channel, resolution 352 × 288/240 pixels
– Modem
For analog modem connections with 20 kbps, resolution 352 × 288/240 pixels
– GSM
For GSM connections at 9,600 baud, resolution 176 × 144/120 pixels
You can choose between the code algorithms MPEG-4 SH++ and H.264 for each data stream.
H.264 requires a lower bandwidth at the same video quality but it does not offer 4CIF
resolution. 4CIF resolution is only possible with MPEG-4 SH++.
1. Select the required profile for every data stream.
2. Select the required code algorithm for every data stream.
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
Preview for
Select which video data stream should be displayed in the previews. You can deactivate the
display of the video images if the performance of the computer is affected too strongly by the
decoding of the data streams.
1. Check the box for the required data stream.
2. Click the i icon above the relevant preview to display further information about the data
stream.
Profile name
You can enter a new name for the profile here. The name is then displayed in the list of
available profiles in the Active profile field.
!
CAUTION!
The profiles are rather complex. They include a large number of parameters that interact with
one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options.
In the default setting, Stream 2 is transmitted for alarm connections and automatic
connections. Bear this fact in mind when assigning the profile.
i
NOTICE!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.