Brother 3600 Printer User Manual


 
21
Ch. 2 Getting Started
Getting Started
Memory: At least 32 MB
USB port (installed as standard equipment)
CD-ROM drive
Installing the P-touch Editor 3.2 soft-
ware
The P-touch Editor 3.2 software includes a vari-
ety of more complex functions for printing bar-
codes and images, enabling you to design just
about any label that you can image. Install the
P-touch Editor 3.2 software onto a Macintosh as
described below.
To install the P-touch Editor 3.2 software
1 With the P-touch and the Macintosh turned
off, connect the P-touch to the computer
using the enclosed USB interface cable as
described on page 10. Be sure to leave the
P-touch turned off.
2 Turn on the Macintosh.
3 Insert the enclosed CD-ROM into the com-
puters CD-ROM drive.
4 Double-click the Mac OS 9 folder to open
it.
5 Double-click the P-touch Editor 3.2 folder
to open it.
6 Double-click the P-touch Editor 3.2 Installer
icon in the folder that appears. The installer
starts up.
7 Select the installation method.
For a basic installation
Clicking the Install button immediately
starts installing all options.
For a custom installation
Clicking the Custom Install button dis-
plays a dialog box that allows you to
select which options to install.
Only the options with a check mark
beside them are installed. Select the
options that you wish to install, and then
click the Install button.
With a Mac OS before OS X:
NOTE
About 20 MB of available hard-disk space is
needed to begin installation. In order to install all
options, about 100 MB of available hard-disk space
is needed. If enough hard-disk space is available,
click the Install button.
NOTE
In order to print from the P-touch 9600/3600,
PT-9600/3600 Driver must be selected for
installation.
If certain options are not installed, some P-
touch Editor functions may not be available.