Filter
Top Products
Chapter 7
38
To enable the machine to work with BT
Call Sign (With your external phone
only)
7
a Press Menu, 2, 0, 3.
0.Miscellaneous
3.BT Call Sign
b Press a or b to choose On (or Off).
Press OK.
c Press Stop/Exit.
Note
If you turn off BT Call Sign, the receive
mode stays in Manual. You will need to
set receive mode again. (See Choosing
the Receive Mode on page 28)
Connecting an external TAD
(telephone answering device)
7
You may choose to connect an external
answering device. However, when you have
an external TAD on the same telephone line
as the machine, the TAD answers all calls
and the machine ‘listens’ for fax calling (CNG)
tones. If it hears them, the machine takes
over the call and receives the fax.
If it does
not hear CNG tones, the machine lets the
TAD continue playing your outgoing message
so your caller can leave you a voice message.
The TAD must answer within four rings (the
recommended setting is two rings). The
machine cannot hear CNG tones until the TAD
has answered the call, and with four rings there
are only 8 to 10 seconds of CNG tones left for
the fax ‘handshake’. Make sure you carefully
follow the instructions in this guide for recording
your outgoing message. We do not recommend
using the toll saver feature on your external
answering machine if it exceeds five rings.
Note
If you do not receive all your faxes, shorten
the Ring Delay setting on your external TAD.
1TAD
When the TAD answers a call, the LCD
shows Telephone (for FAX-1355) and
Ext. Tel in Use (for FAX-1360,
FAX-1460 and FAX-1560).
Improper Setup
Do not connect a TAD elsewhere on the
same phone line.
1
1