Filter
Top Products
Chapter 9
50
Additional TAD
operations
9
Setting maximum time for
incoming messages 9
Your machine’s default setting will save
incoming messages up to 30 seconds long.
To change this setting follow the steps below:
a Press Menu, 2, 7, 2.
7.Setup TAD
2.ICM Max.Time
b Press a or b to choose the maximum
time setting for incoming messages (30,
60, 120 or 180 seconds).
Press OK.
c Press Stop/Exit.
Setting toll saver 9
When the toll saver feature is on, the machine
will answer after two rings if you do have
voice or fax messages, and after four rings if
you do not have any messages.
This way, when you call your machine for
remote retrieval, if it rings three times, you
have no messages and can hang up to avoid
a toll charge.
The toll saver feature is only available when
TAD mode is on. When toll saver is On, it
overrides your ring delay setting.If you are
using BT Call Sign, do not use the Toll Saver
feature.
a Make sure you are in fax mode. If not
then press (Fax).
b Press Menu, 2, 1, 1.
1.Setup Receive
1.Ring Delay
c Press a or b to choose Toll Saver.
Press OK.
d Press a or b to choose On (or Off).
Press OK.
e Press Stop/Exit.
ICM Recording Monitor 9
This feature lets you turn the speaker volume
for voice messages On or Off. When you turn
the monitor Off, you will not hear messages
as they come in.
a Press Menu, 2, 7, 3.
7.Setup TAD
3.ICM Rec.Monitr
b Press a or b to choose Off or On.
Press OK.
c Press Stop/Exit.
Recording conversation
(FAX-1460 only) 9
If you are using the handset, you can record
a telephone conversation by pressing
Play/Record during the conversation. Your
recording can be as long as the incoming
message maximum time (up to 3 minutes).
The other party will hear an intermittent
beeping while recording. To stop recording,
press Stop/Exit.