Filter
Top Products
Accessory List
A - 1
Accessory List
*For optimum print quality and product performance within
published specifications, use only the correct Brother
replacement ribbon. Brother does not recommend the use of
consumables other than genuine Brother consumables.
Failure to use the genuine Brother consumable may damage
the machine and any repair required as a result may not be
covered under warranty.
Model Name Description
PC-501 Printing Cartridge and a re-fill (1 set per box)
PC-402RF 2 re-fills for use in PC-501 Printing Cartridge
PC-404RF 4 re-fills for use in PC-501 Printing Cartridge
PC-AS4RF 4 re-fills for use in PC-501 Printing Cartridge
(Not available in Australia and New Zealand)
Change Receive Mode
Press 9 8.
then for TA D, press 1.
FAX/TEL, press 2.
FAX ONLY, press 3.
Exit Remote Operation
Press 9 0.
Change Remote Access Code
1
Press Menu/Set, 8, 2.
2
Enter a three-digit number. The cannnot be changed.
3
Press Menu/Set.
4
Press Stop/Exit.
Using Remote Access Code
1
Dial your machine phone number from a touch tone
phone.
2
Enter your Remote Control Access Code (3 digits
followed by ) after the beep.
3
Your machine signals the kinds of messages received:
1 long beeps – Fax message(s)
No beeps – no messages
4
After 2 short beeps, enter a command.
5
Press 9 0 to reset your machine when you finish.
6
Hang up.
R
EMOTE
C
ONTROL
A
CCESS
C
ARD
Retrieve a Fax
Press 9 6.
then to Print a Memory Status List press
1, then enter the number of remote
fax machine, and then # #. After
the beep, hang up and wait.
Retrieve all faxes press 2, then
enter the number of remote fax
machine, and then # #. After the
beep, hang up and wait.
Erase all fax messages press 3.
Check Receiving Status
Press 9 7.
then for Fax message, press 1.
Voice message, press 2.
1 long beeps – received messages
3 short beeps – no messages
Change Receive Mode
Press 9 8.
then for TAD:MSG MGR, press 1.
FAX/TEL, press 2.
FAX ONLY, press 3.
Exit Remote Operation
Press 9 0.
Using Remote Access Code
1
Dial your fax machine phone number from a
touch tone phone.
2
Enter your Remote Access Code
(3 digits followed by ) after the beep.
3
The fax machine signals the kinds of
messages received:
1 long beep – Fax message(s)
2 long beeps – Voice message(s)
3 long beeps – Fax and Voice message(s)
No beeps – no messages
4
After 2 short beeps, enter a command.
5
Press 9 0 to reset the machine when you
finish.
6
Hang up.
M
ESSAGE
M
ANAGER
REMOTE
CONTROL
ACCESS
CARD
(For FAX-817/827)
(For FAX-837MC)
1
14
5 6