Filter
Top Products
CHAPTER 2 SETTING UP THE PRINTER
2–9
Installing the Oil Bottle and the Fuser Cleaner
1. Open the Top Cover and release the pressure on the Fusing Unit rollers by pushing the
Pressure Release Levers to the OPEN position ( ). Remove the orange protective
parts fitted between the rollers of the Fusing Unit ( ). Make sure that the Pressure
Release Levers are put back to the SET position. .
Fig. 2-14 Remove the Protective Parts
2. Install the Oil Bottle into the Fusing Unit with the label side facing the front of the
printer. The Oil Bottle is keyed to prevent incorrect installation.
Fig. 2-15 Install the Oil Bottle
!
Caution
Do not spill the oil inside the printer. If the oil does spill, it might cause
damage to the printer. If you do spill any oil, consult your dealer or our
authorized service representative.