Filter
Top Products
Troubleshooting and routine maintenance
141
C
Out of Memory The machine’s memory is full. Fax sending or copy operation in progress
Do one of the following:
Press Start to send or copy the scanned
pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See Out
of memory message on page 47 or
page 92.)
Print operation in process
Do one of the following:
Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the
CD-ROM.)
Clear the faxes from the memory. (See Out
of memory message on page 92.)
Print Unable XX The machine has a
mechanical problem.
Disconnect the machine from the power for
several minutes, then reconnect it. (The
machine can be turned off for approximately 60
hours without losing faxes stored in the
memory. See Transferring your faxes or Fax
Journal report on page 144.)
Protected Device The protect switch of the USB
Flash memory drive is on.
Turn off the protect switch of the USB Flash
memory drive.
Rename the File There is already a file on the
USB Flash memory drive with
the same name as the file you
are trying to save.
Change the file name of the file on the USB
Flash memory drive or the file you are trying to
save.
Replace Parts
Drum
The drum unit is the end of its
life.
Replace the drum unit.
(See Replacing the drum unit on page 164.)
The drum unit counter was not
reset when a new drum was
installed.
1 Open the front cover, and then press
Clear/Back.
2 Press 1 to reset.
Replace Parts
Fuser Unit
It is time to replace the fuser
unit.
Call Brother Customer Service to replace the
fuser unit.
1-877-BROTHER (1-877-276-8437) (in U.S.A)
1-877-BROTHER (in Canada)
Error Message Cause Action