Filter
Top Products
2-162 SmartCell 6A000/ZX-250 Reference Manual
Console Commands
Descriptions
Examples
switch_prompt # add route
DestNetIP() : 204.95.77.187
GatewayIP() : 204.95.77.186
switch_prompt #
switch_prompt # show route
ROUTE NET TABLE
destination gateway flags Refcnt Use Interface
------------------------------------------------------------------------
90.1.1.0 90.1.1.186 1 0 6508 zn1
204.95.77.0 204.95.77.186 1 3 6312 ei0
------------------------------------------------------------------------
ROUTE HOST TABLE
destination gateway flags Refcnt Use Interface
------------------------------------------------------------------------
127.0.0.1 127.0.0.1 5 0 0 lo0
204.95.77.187 204.95.77.186 5 0 0 ei0
------------------------------------------------------------------------
switch_prompt #
switch_prompt # delete route
DestNetIP() : 204.95.77.187
GatewayIP() : 204.95.77.186
switch_prompt #
Operator Parameters/Permissions Description
add route [DestNetIP] <destnetip>
[GatewayIP] <gatewayip>
Administrator
Creates an IP route to an ATM client when it is not directly
connected to the NMS (network management system). You
must assign both the destination IP address and the gateway IP
address to reach the ATM client, and these addresses must
already exist.
delete
route
[DestNetIP] <destnetip>
[GatewayIP] <gatewayip>
Administrator
Removes an IP route from the switch configuration when it is
not directly connected to the NMS.
show route
All Displays IP routes used by the switch. The flag numbers shown
in the flags column relate to the hexadecimal figures listed in the
Output Parameter table above. Whatever number is shown
defines what flags are active. For example, 1 equals flag 0x1; 5
equals flag 0x1 + flag 0x4; 7 equals flag 0x1 + flag 0x2 + flag
0x4 and so on.