Filter
Top Products
Chapter 3: Local Management
3-46 HSIM-A6DP User’s Guide
UNI Q93b Status (Read-Only)
This is a read-only field that displays the current UNI Q93b status. If the
HSIM-A6DP is connected to an ATM network, this field should read
“Enabled”. If this field reads “Disabled” UNI did not start up correctly,
and some UNI services may not be available. If this field remains in a
disabled state, check that all appropriate UNI services in the ATM
network have been configured properly.
UNI Version (Toggle)
This field displays the current version of UNI being used by the
HSIM-A6DP. This field is modifiable if signaling is enabled manually by
the user. In autoconfigure mode the HSIM-A6DP uses either UNI 3.0 or
UNI 3.1, depending on the version of UNI being used by the ATM switch
to which the HSIM-A6DP is connected.
SAVE (Command)
This command saves all changes to memory.
RESTART UNI (Command)
This command restarts UNI. For instructions on how to restart UNI, refer
to Section 3.15.5.
RESTART ILMI (Command)
This command restarts the ILMI. For instructions on how to restart the
ILMI refer to Section 3.15.6.
3.15.2 Changing the ILMI Status
To change the ILMI status from the default state of [Auto Configure
Enabled] perform the following steps:
1. Use the arrow keys to highlight the ILMI Status field.
2. Use the SPACE bar until the option [Enabled] displays.
!
CAUTION
Before completing the following step, ensure that this caution is
fully understood. By disabling the ILMI, ALL SVCs currently
configured on the HSIM-A6DP will be lost.