Filter
Top Products
Using the Stand-alone Launcher
Adding Devices to the Launcher Database 4-7
Figure 4-2. SPMA Launcher Add Device window
2. Enter the device’s Host Name or IP Address, as desired, by
clicking in the appropriate selection box to place the cursor in the
text box, then entering the value.
3. Click to place the cursor in the Polling Rate text box, then enter
the interval (in seconds) at which you want the Launcher to poll
the device. The minimum polling time is 5 seconds, and the
maximum is 65,535 seconds; the default value is 600 seconds.
NOTES
If you wish to use a hostname instead of an IP address, there must be a
hostname mapped to your deviceÕs IP address; please note, however, that the
hostname is not the same as the device name which can be assigned via Local
Management and/or SPMA. You cannot use the device name in place of the
IP address.
The Stand-alone Launcher will not allow you to use the same IP address
twice.
00-Instl_SEM-Solaris_Book Page 7 Monday, October 5, 1998 11:41 AM