Cabletron Systems SmartSwitch Network Router User Manual


 
SmartSwitch Router User Reference Manual 267
Chapter 17: Access Control List Configuration Guide
This command creates a Profile ACL called prof3 that uses as its selection criteria all IGMP
traffic on the SSR:
The following command causes packets matching Profile ACL prof3’s selection criteria
(that is, all IGMP traffic) to be copied to mirror port et.1.2.
See “Configuring the SSR for Port Mirroring” on page 297 for more information on using
the port mirroring command.
Using Profile ACLs with the Web Caching Facility
Web caching is the SSR’s ability to direct HTTP requests for frequently accessed Web
objects to local cache servers, rather than to the Internet. Since the HTTP requests are
handled locally, response time is faster than if the Web objects were retrieved from the
Internet.
You can use Profile ACLs with Web caching in two ways:
Specifying which HTTP traffic should always (or never) be redirected to the cache
servers
Specifying characteristics of Web objects that should not be cached
Redirecting HTTP Traffic to Cache Servers
You can use a Profile ACL to specify which HTTP traffic should always (or never) be
redirected to the cache servers. (By default, when Web caching is enabled, all HTTP traffic
from all hosts is redirected to the cache servers unless you specify otherwise.)
For example, you can specify that packets with a source address of 10.10.10.10 and a
destination address of 1.2.3.4 always are sent to the Internet and never to the cache
servers. The following commands illustrate this example.
This command creates a Profile ACL called prof4 that uses as its selection criteria all
packets with a source address of 10.10.10.10 and a destination address of 1.2.3.4 :
The following command creates a Web caching policy that prevents packets matching
Profile ACL prof4’s selection criteria (that is, packets with a source address of 10.10.10.10
ssr(config)# acl prof3 permit igmp
ssr(config)# port mirroring monitor-port et.1.2 target-profile prof3
ssr(config)# acl prof4 permit ip 10.10.10.10 1.2.3.4