Filter
Top Products
SmartSwitch Router User Reference Manual 309
Chapter 21: RMON Configuration Guide
1
To display Ethernet statistics and related statistics for WAN ports, RMON has to be
activated on that port. To activate RMON on a port, use the
frame-relay define service
or
ppp define service
command, and the
frame-relay apply service
or
ppp apply service
command. For addional information, refer to “Setting up a Frame Relay Service Profile”
on page 324 (for frame relay) and “Setting up a PPP Service Profile” on page 328 (for PPP).
RMON CLI Filters
Because a large number of statistics can be collected for certain RMON groups, you can
define and use CLI filters to limit the amount of information displayed with the
rmon
show
commands. An RMON CLI filter can only be applied to a current Telnet or Console
session.
To display the RMON 2
Address Map table.
rmon show address-map <port-list>|all-ports
To show Network Layer Host
logs.
rmon show nl-host<port-list>|all-ports [summary]
To show Application Layer
Host logs.
rmon show al-host<port-list>|all-ports [summary]
To show Network Layer
Matrix logs.
rmon show nl-matrix<port-list>|all-ports [order-by
srcdst|dstsrc] [summary]
To show Application Layer
Matrix logs.
rmon show al-matrix<port-list>|all-ports [order-by
srcdst|dstsrc] [summary]
To show all Network Layer
Matrix Top N.
rmon show nl-matrix-top-n
To show all Application
Layer Matrix Top N.
rmon show al-matrix-top-n
To show all user history logs.
rmon show user-history
To show probe configuration.
rmon show probe-config [basic] [net-config] [trap-
dest]