Filter
Top Products
SmartSwitch Router User Reference Manual 287
Chapter 19: QoS Configuration Guide
Setting an IP QoS Policy
To set a QoS policy on an IP traffic flow, enter the following command in Configure mode:
For example, the following command assigns control priority to any traffic coming from
the 10.10.11.0 network:
Specifying Precedence for an IP QoS Policy
To specify the precedence for an IP QoS policy, enter the following command in Configure
mode:
Configuring IPX QoS Policies
To configure an IPX QoS policy, perform the following tasks:
1. Identify the Layer-3 or 4 flow, and set the IPX QoS policy.
2. Specify the precedence for the fields within an IPX flow.
Setting an IPX QoS Policy
To set a QoS policy on an IPX traffic flow, enter the following command in Configure
mode:
Set an IP QoS policy.
qos set ip <name> <priority> <srcaddr/mask>|any
<dstaddr/mask>|any <srcport>|any <dstport>|any
<tos>|any <port list>|<interface-list>|any
<protocol>|any <tos-mask>|any <tos-precedence-
rewrite>|
any <tos-rewrite>|any
ssr(config)# qos set ip xyz control 10.10.11.0/24
Specify precedence for an
IP QoS policy.
qos precedence ip [sip <num>] [dip <num>]
[srcport
<num>] [destport <num>]
[tos
<num>] [protocol <num>] [intf
<num>]
Set an IPX QoS policy.
qos set ipx <name> <priority> <srcnet>|any
<srcmask>|any <srcport>|any <dstnet>|any
<dstmask>|any <dstport>|any <port list>|<interface-
list>
|any