Filter
Top Products
Chapter 1: SSR Product Overview
36 SmartSwitch Router User Reference Manual
To exit Enable mode and return to User mode, use one of the following commands:
ip - Show IP related parameters
ip-policy - Show IP policy information
ip-redundancy - Show IP Redundancy information (VRRP)
ip-router - Show unicast IP Routing related parameters
ipx - Show IPX related parameters
l2-tables - Show L2 Tables information
lfap - Show LFAP parameters
load-balance - Show Load Balancing related parameters and
hosts
logout - Log off the system
mtrace - Multicast Traceroute utility
multicast - Configure Multicast related parameters
nat - Show Network Address Translation related
parameters
ntp - Network Time Protocol (NTP)
ospf - Show/Monitor Open Shortest Path First Protocol
(OSPF).
ping - Ping utility
port - Show or change Port parameters
ppp - Display Point to Point Protocol (PPP)
statistics
pvst - Show Per Vlan Spanning Tree Protocol (PVST)
parameters
qos - Show Quality of Service parameters
radius - Show RADIUS related parameters
rate-limit - Show rate-limit policy information
rdisc - Show Router Discovery Protocol (RIP) parameters
reboot - Reboot the system
rip - Show/Query Routing Information Protocol(RIP)
tables
rmon - Show RMON related parameters
sfs - Show SecureFast Switching (SFS) parameters
smarttrunk - Show SmartTRUNK information
snmp - Show SNMP related parameters.
statistics - Show or clear SSR statistics
stp - Show STP status
system - Show system-wide parameters
tacacs - Show TACACS related parameters
tacacs-plus - Show TACACS+ related parameters
telnet - Telnet utility
traceroute - Traceroute utility
vlan - Show VLAN-related parameters
web-cache - Configure web caching parameters
Exit Enable mode.
exit
Ctrl+Z