Cabletron Systems STS16-20R Switch User Manual


 
92
SmartStack STS16-20D/STS16-20R Token Ring Switches Installation and User Guide Switch Configuration
1005 and 1 are reserved for the default BRFs and CRFs. These values cannot be
changed.
VLAN Name
ASCII name associated with the BRF. Up to 32 characters are allowed. The name
must be unique. Neither BRFs nor CRFs can have identical names.
State
Current state of the BRF. Possible values are
Operational
and
Suspended
. BRFs in
operational state are functional. BRFs in suspended state do not pass packets. The
default is operational.
MTU
Maximum Transfer Unit of the BRF (maximum size of the information field in
transmitted packets). Possible values are 1,500, 4,472 (default), 8,144, and 17,800.
The actual value used also depends on the hardware and the value configured for
the port (the smaller value is used).
These values correspond to maximum frame size values of
1,548
,
4,546
(default),
9,236
, and
18,192
respectively.
The actual value used depends on the hardware and the value configured for the
ports (the smaller value is used).
Bridge Number
Source routing bridge number for this BRF. Possible hexadecimal values are 0
through F. The default is F.
802.1Q VLAN ID
This parameter configures the QTAG to be used for High-Speed Token-Ring and
Translational Switching. If Q-tagging is used for this BRF, the default is set to the
VLAN ID of the BRF. Refer to the guide shipped with the relevant module (only
relevant for the SmartStack STS16-20RM/STS16-20FRM switches).
LAA VLAN MAC Address
Used to configure a LAA MAC address used for in-band management of the
switch.
Note!
The switch must be rebooted before this configuration takes effect.