Cabletron Systems STS16-20R Switch User Manual


 
95
Switch Configuration SmartStack STS16-20D/STS16-20R Token Ring Switches Installation and User Guide
default for the class of the IP address. If a subnet mask is specified, it will be used
as a net mask.
Default: 0.0.0.0
IP State
Display the following choices by highlighting
IP State
and pressing
ENTER
:
IP Disabled
BootP When Needed
BootP Always
Then highlight one of these choices and press
ENTER
. The meaning of these values
are as described in the following:
IP Disabled
When a VLAN is IP-disabled, it will not process any IP or ARP
packets it receives. This means that no Ping, Telnet, or ARP Packets will be
responded to when received. SNMP management is only possible over MAC.
BootP When Needed
In this state, the switch will send out BootP requests at
regular intervals on all ports in the VLAN until the VLAN is assigned an IP
address different from
0.0.0.0
or
192.0.2.1
.
The assignment can come from NVRAM during a boot, from the console
management or via BootP.
BootP Always
In this state, the switch will at boot time clear the IP address
assigned to this VLAN and send out BootP requests at regular intervals until it
receives a BootP answer. Then normal IP communication will resume.
Note:
For the default BRF the default
IP State
value is
BootP when Needed
. For
all the other VLANs the default is
IP Disabled
Send PING
Prompts you to enter an IP address to which the switch will attempt ping.
Note
! The configuration of the IP-address, default gateway etc. takes effect when
you close the
IP Configuration
screen. This means that if any parameter has been
changed you have to return to the
Configuration
menu and enter the
IP
Configuration
screen before attempting to ping. Otherwise the old values will be
used.