Cabletron Systems STS16-20R Switch User Manual


 
153
Switch Configuration SmartStack STS16-20D/STS16-20R Token Ring Switches Installation and User Guide
Reset Port Address Table
Selecting this command clears all address table entries for a specified port (user is
queried for which port to reset), sets port traffic counters to zero, and sets
Time
Since Last Reset
for this port to zero.
Clear Nonvolatile RAM
Selecting this command will erase all user-configured parameters and reset the
switch.
Note:
Clearing NVRAM (non-volatile RAM) erases all configuration parameters.
Follow these guidelines if you must clear NVRAM:
If you are using the CrossLink feature, be sure to disconnect the affected
portsor disable them on the
Port Configuration
screen and reset the
switch
before
clearing NVRAM.
If you are using the STP option, be aware that port costs and priorities will be
lost, which may result in loops. Use the menus to reestablish port costs and
priorities, then reset the switch to make the new parameters take effect.
If you are using an SNMP manager, you will need to reconfigure all IP and
SNMP parameters.
Power-On Diagnostics
This is a selectable option that determines whether diagnostics are, or are not,
initiated during a SmartStack STS16-20D/STS16-20R power-on sequence. To
change the selection, highlight the item and press
ENTER
; then select
Enabled
or
Disabled
, and press
ENTER
.
Default:
Enabled