Filter
Top Products
Settings Menu
3-37
3
Printer Settings Menu
Creep Correction
Off
*
, Auto, and Correction Width (0.000 to 0.392 inches (in increments of
0.001 inches); 0.000
*
inches)
This setting enables you to adjust the print position of each page when printing a
booklet using saddle stitch.
When sheets of paper are folded in half to make a booklet, the edges of the paper
protrude more the closer the pages are to the center of the booklet. Margin width
at the edges is narrowed, and part of the printing may also be cut off (depending
on the number of pages and paper thickness when the edges are trimmed to
make them even). Using creep correction to adjust the margin of the gutter can
correct such uneven printing (creep).
If [Auto] is selected, the gutter margins are automatically adjusted based on the
number of pages and paper thickness.
If [Correction Width] is selected, the gutter widths are adjusted based on a value
you enter which specifies the difference in how far the edge of the most inner
page and the edge of the most outer page come when sheets of paper are folded
in half to make the booklet.
When the gutter margins are adjusted with this setting
Trimming
Adjusted so that the gutter margin width is wider the
more outer the page, and narrower the more inner the page
After trimming, the page
margin widths are all even
After trimming, the page
margin widths are all uneven
When [Off] is selected
Trimming
Gutter margin
Print position is more
off-center the closer
the pages get to the
middle
Printing area
Edge margin