Filter
Top Products
Settings Menu
3-24
3
Printer Settings Menu
■ Offset Short Edge/Offset Long Edge (Front)
-2.00 to +2.00 inches (in increments of 0.01 inches); 0.00
*
inches
This setting enables you to set the offset position. The settings can be set in
increments of 0.01" (0.5 mm) from -2.00" (-50.0 mm) through +2.00" (+50.0 mm).
The print position on the front page is adjusted in the vertical or horizontal
direction to the value specified in the setting value.
To adjust the print position on the back page, set 'Offset Short Edge/Offset Long
Edge (Back)' (the next setting).
You can increase or decrease the setting in increments of 0.01" (0.5 mm) to
adjust the print position, as described below.
Offset Short Edge (Front): Increasing the setting value moves the image in the
rightward X direction on the paper. Decreasing the setting value moves the image
in the leftward X direction on the paper.
Offset Long Edge (Front): Increasing the setting value moves the image in the
downward Y direction on the paper. Decreasing the setting value moves the
image in the upward Y direction on the paper.
IMPORTANT
Please note that if the print position is adjusted to place print data outside the
printable area, the portion outside the printable area is not printed.
NOTE
•
If this setting is used in combination with 'Margin', the values of the two settings are
added together.
•
Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is
pressed. Pressing [ ] decreases the value by 0.01" (0.5 mm) each time. Holding
down either [ ] or [ ] continuously speeds up the value alteration.
ABC
X
Y
Adjust using
X/Y-Adjustment
Area adjusted using
Y-Adjustment
[+]
Area adjusted using
X-Adjustment
[+]
Front Front
ABC
Part of the
original margin