Filter
Top Products
NetBIOS Network Setup Procedures
5-2
5
Using a NetBIOS Network
NetBIOS Network Setup Procedures
To use a NetBIOS network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p. 5-3.)
Specify the protocol settings. To specify the settings, use:
• The machine's control panel
• The Remote UI (via a web browser)
2
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 5-6.)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to
print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 5-11.)
Specify the settings of the computer receiving data sent from the machine.
IMPORTANT
•
If you are using the optional imagePASS or the optional ColorPASS, for steps 1 and 2,
see the manual provided with the optional imagePASS or the optional ColorPASS, not
this guide.
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
The only base protocol supported by the machine for NetBIOS networks is TCP/IPv4.
TCP/IPv6 and NetBEUI are not supported (SMB is used as a print application).