Filter
Top Products
Appendix B Options B-3
Options
Attaching the Handset to Your MultiPASS
Follow this procedure to attach the handset to your MultiPASS:
1 Use a screwdriver to remove the two
covers on the left side of the unit.
2 Remove the screws from the plugs and
insert the plugs into the holes on the
handset cradle. Then insert the plugs
(with the handset cradle) into the holes
on the unit.
• If you have difficulty inserting the plugs, turn
the unit so that the left side is facing you
and the right side is against a wall. This will
allow you to insert the plugs without the unit
moving.
3 Use your finger to push the screws into
the plugs.
• If you have difficulty, use a cross-point
screwdriver to push the screws all the way
into the plugs. (Do not screw them in as the
screws may break.)
• Make sure you support the unit when
inserting the screws.
4 Place the handset in its cradle and
connect the line from the handset to the
t jack.