Filter
Top Products
Chapter 14 Summary of Settings 14-7
Summary of
Settings
ECM RX
RX MODE
INCOMING RING
RING COUNT
MAN/AUTO SWITCH
F/T RING TIME
REMOTE RX
REMOTE RX ID
MEMORY RX
COLOUR RX
Enables/disables Error Correction Mode (ECM) during
reception.
Selects the receive mode. (1 Chapter 8)
If you select FAX/TEL AUTO SW, you can select
additional sub-settings. (1 p. 8-6)
When the MultiPASS is set to FAX ONLY MODE or
FAX/TEL AUTO SW, enables/disables ringing when
the MultiPASS receives a call.**
Selects the number of incoming rings before the
MultiPASS begins receiving.
When the MultiPASS is set to MANUAL MODE,
determines if the MultiPASS switches to fax receive
mode after it rings for a specified time.
If you select ON above, selects the length of time the
MultiPASS rings before switching to fax receive mode.
Enables/disables remote receiving.
If you select ON above, selects the remote receiving ID.
Enables/disables memory reception of a document
(e.g. when an error occurs).
Enables/disables colour fax reception. (1 p. 8-12)
ON
OFF
FAX ONLY MODE
NET SWITCH*
FAX/TEL AUTO SW
OFF
ON
2 TIMES
(1 to 99)***
OFF
ON
15 SEC
(1 to 99)
ON
OFF
25
(00 to 99)
ON
OFF
ON
OFF
(Default settings are shown in bold type.)
*NET SWITCH is only available in Australia and New Zealand. (1 pp. 8-14, 8-16)
**Even if you have set INCOMING RING to ON, ringing will only occur if you have connected the optional handset
or a telephone to your unit.
***New Zealand: 1 to 5.
RX (Reception) Settings Menu
For details on accessing the settings below, 1 pp. 14-2, 14-3.
Setting Description Sub-Settings