Canon LR1 Printer User Manual


 
The last part of the document does not print
Is the printer properly Firmly connect the power cord and the printer cable.
connected to the Internet
device?
Printing starts, but stops before it is finished
Does the document involve When printing documents that involve a large amount
a large amount of data, such of data, it may take several moments before printing
as photos and illustrations? starts. If the
BUSY light is green, print data is being
sent to the printer. Wait for printing to start.
Has the printer been If you print for extended periods of time, the BJ
printing for an extended cartridge overheats and the RESUME/CLEAN light
period of time? flashes. If this happens, stop printing and wait until
the BJ cartridge has cooled. When the BJ cartridge is
cool, the light stops flashing.
The printer is printing garbage
Was the previous printing Data from the previously printed job may be left in
job cancelled while it was the printer’s memory. Turn off the power to the
still printing? printer and the Internet device, then turn the power
on again.
Is the printer properly Firmly connect the power cord and the printer cable.
connected to the Internet
device?
Is the data printout If unreadable characters are printed only when
correct? printing certain data, there may be a problem with the
data or the application software. Re-create the data and
print again. If the problem persists, call the Canon
Customer Care Center (see page 1-13).
Troubleshooting
Chapter 5 Troubleshooting 5-7