Filter
Top Products
33
ENGLISH
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1 quick-release adjuster foot and 1
rear adjuster foot. These adjusters change the image height and
projection angle. To adjust the projector:
1. Press the quick-release button and lift the front of the projector.
Once the image is positioned where you want it, release the
quick-release button to lock the foot in position.
2. Screw the rear adjuster foot to fine tune the horizontal angle.
To retract the foot, hold up the projector while pressing the quick-
release button, then slowly lower the projector. Screw the rear
adjuster foot in a reverse direction.
If the projector is not placed on a flat surface or the screen and the
projector are not perpendicular to each other, the projected image
becomes trapezoidal. To correct this situation, see "Correcting
keystone" on page 34 for details.
• Do not look into the lens while the lamp is on. The strong
light from the lamp may cause damage to your eyes.
• Be careful when you press the adjuster button as it is close
to the exhaust vent where hot air comes from.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do
this, press AUTO PC on the projector or remote control. Within 3
seconds, the built-in Intelligent Auto Adjustment function will re-
adjust the values of Frequency and Clock to provide the best picture
quality.
The current source information will be displayed in the upper left
corner of the screen for 3 seconds.
• The screen will be blank while AUTO PC is functioning.
• This function is only available when a PC signal (analog
RGB) is selected.
Fine-tuning the image clarity
For adjusting the size to your desired, you need to move the
product for appropriate projection distance. Follow the procedure
below for the installation and adjustment.
The focus will be off after adjusting the projection distance, so be
sure to readjust the focus. If the image is very blurry, adjusting the
focus to make the image sharp will change the size of the projected
image. Adjust the projection distance and focus repeatedly in
alternation as necessary.
2
1