Filter
Top Products
73
ENGLISH
Control Commands
You can control this projector by sending commands via CONTROL port or LAN port.
System Requirement
CONTROL port
LAN port
Control Command
Connection Cable 9-pin RS-232-C Cable (Crossover)
Communication Mode RS-232-C asynchronous, half-duplex communication
Baud Rate 19200 bps
Character Length 8 bit
Parity Check None
Stop Bits 2 bit
Flow Control None
Connection System TCP/IP Connection
Port 33336
Function
Read/
Write
Operation Command (ASCII) Note
Power
W Power On POWER=ON<CR>
Enable during
“Standby” state.
W Power Off POWER=OFF<CR>
R Power Status GET=POWER<CR>
Enable during any
power state.
[Warming up]
g:POWER=OFF2ON
[Cooling down]
g:POWER=ON2OFF
Source
Selection
W Computer1 INPUT=DSUB1<CR>
W Computer2 INPUT=DSUB2<CR>
W HDMI INPUT=HDMI<CR>
W Video INPUT=VIDEO<CR>
W S-Video INPUT=S-VIDEO<CR>
R Current source GET=INPUT<CR>
Audio
Control
W Mute On MUTE=ON<CR>
W Mute Off MUTE=OFF<CR>
R Mute Status GET=MUTE<CR>
W Volume + RC=VOL_P<CR>
W Volume - RC=VOL_M<CR>
R Volume Status GET=AVOL<CR>