Filter
Top Products
6-1
6
Special Features
Chapter 6
Special Features
Special Dialling
This section explains special dialling features, such as dialling an overseas number, switching temporarily to
tone dialling, and confirming a dial tone.
■ Dialling an Overseas Number (With Pauses)
When you dial or register an overseas number, you may need to insert a pause within and/or after the number.
The length and location of the pause depends on the telephone system of your country.
1 Press Fax to set Fax Mode.
2 Prepare the document and place it on the platen glass or
load it into the ADF.
• If you use the platen glass, the LCD displays the standby mode.
• For colour sending, press Colour/B&W to turn on its light.
(→ p. 4-1)
• To adjust the resolution and contrast, → p. 4-2.
3 Use the numeric buttons to dial the international access
code.
• If you enter the wrong number, press Stop/Reset, then enter
the correct number.
• For details on international access codes, contact your local
telephone company.
4 If necessary, press Redial/Pause to enter a two-second*
pause (p).
• For a longer pause, press Redial/Pause again for another two-
second* pause. Alternatively, you can change the length of the
pause. (→ MID PAUSE SET, p. 9-5)
* The pause length varies depending on the current country selection.
5 Use the numeric buttons to dial the country code, the area
code, and the fax/telephone number of the other party.
• If you enter the wrong number, press Stop/Reset and start
again from step 3.
6 If necessary, press Redial/Pause to enter a pause.
• A pause at the end of a number (P) is fixed to ten seconds.
Ex:
27/12 2002 FRI 15:30
FaxOnly STANDARD
Ex:
MEMORY USED
0%
(Currently used memory)
DOCUMENT READY
(Standby to scan)
Ex:
TEL= 00
Ex:
TEL= 00P
Ex:
TEL= 00p81123
Ex:
TEL= 00p81123P