Filter
Top Products
4
CHRISTIE DIGITAL SYSTEMS P35GPS Projector
March, 2004
4-1
4. OPERATING THE PROJECTOR
4.1. GENERAL
Before operating the projector, verify that all phases of installation and assembly have been
completed.
WARNING
• Verify that cover for belt side of projector is installed before and
during operation.
• Do not make adjustments on belt side of projector while cover is
removed or power is on.
• Do not make adjustments or perform maintenance on projector
while it is in operation.
4.2. PRE-OPERATING PROCEDURES
4.2.1. FLYWHEEL I NSTALLATION
1. Back out flywheel set screw far enough to let flywheel slide onto shaft without scoring
shaft or damaging threads on set screw.
2. Slide flywheel onto shaft until it stops.
3. Position set screw over flat portion of shaft and tighten set screw.
4. Spin flywheel by hand to check for smooth operation.
CHRISTIE recommends that any projector accessories be installed at
this time.
4.2.2. TURRET I NSTALLATION
1. Secure turret hinge plate with four Allen head screws.
2. Install turret latch assembly using same holes and hardware (if it is not already installed).
3. Connect turret wiring to TB4-1 (Red) and TB4-2 (Black).