Filter
Top Products
16-3
Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide R8.5
78-18133-01
Chapter 16 Configuring Bridging on the ML-Series Card
Monitoring and Verifying Bridging
Figure 16-1 Bridging Example
Example 16-1 ML_Series A Configuration
bridge irb
bridge 1 protocol ieee
!
!
interface FastEthernet0
no ip address
bridge-group 1
!
interface POS0
no ip address
bridge-group 1
Example 16-2 ML_Series B Configuration
bridge irb
bridge 1 protocol ieee
!
!
interface FastEthernet0
no ip address
bridge-group 1
!
interface POS0
no ip address
bridge-group 1
Monitoring and Verifying Bridging
After you have set up the ML-Series card for bridging, you can monitor and verify its operation by
performing the following procedure in privileged EXEC mode:
fast ethernet 0
pos 0pos 0
fast ethernet 0
ML_Series_A
ML_Series_B
124411
SONET/SDH
Command Purpose
Step 1
ML_Series# clear bridge
bridge-group-number
Removes any learned entries from the forwarding database of a
particular bridge group, clears the transmit, and receives counts
for any statically configured forwarding entries.
Step 2
ML_Series# show bridge
{
bridge-group-number
|
interface-address
}
Displays classes of entries in the bridge forwarding database.