Filter
Top Products
3-10
Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide R8.5
78-18133-01
Chapter 3 Initial Configuration of the ML-Series Card
Cisco IOS Command Modes
Note When a process makes unusually heavy demands on the CPU of the ML-Series card, it might impair CPU
response time and cause a CPUHOG error message to appear on the console. This message indicates
which process used a large number of CPU cycles, such as the updating of the routing table with a large
number of routes due to an event. Seeing this message as a result of card reset or other infrequent events
should not be a cause for concern.
When you start a session on the ML-Series card, you begin in user EXEC mode. Only a small subset of
the commands are available in user EXEC mode. To have access to all commands, you must enter
privileged EXEC mode, also called Enable mode. From privileged EXEC mode, you can type in any
EXEC command or access global configuration mode. Most of the EXEC commands are single-use
commands, such as show commands, which show the current configuration status, and clear commands,
which clear counters or interfaces. The EXEC commands are not saved across reboots of the ML-Series
card.
Table 3-2 Cisco IOS Command Modes
Mode What You Use It For How to Access Prompt
User EXEC Connect to remote devices,
change terminal settings on a
temporary basis, perform basic
tests, and display system
information.
Log in.
Router>
Privileged EXEC
(also called Enable
mode)
Set operating parameters. The
privileged command set includes
the commands in user EXEC
mode, as well as the configure
command. Use this command
mode to access the other
command modes.
From user EXEC mode, enter the
enable command and the enable
password.
Router#
Global configuration Configure features that affect the
system as a whole.
From privileged EXEC mode,
enter the configure terminal
command.
Router(config)#
Interface configuration Enable features for a particular
interface. Interface commands
enable or modify the operation
of a Fast Ethernet or POS port.
From global configuration mode,
enter the interface type number
command.
For example, enter
interface fastethernet 0 for
Fast Ethernet or interface pos 0
for POS interfaces.
Router(config-if)#
Line configuration Configure the console port or vty
line from the directly connected
console or the virtual terminal
used with Telnet.
From global configuration mode,
enter the line console 0
command to configure the
console port or the
line vty line-number command
to configure a vty line.
Router(config-line)#