Filter
Top Products
Index
IN-15
Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide R8.5
78-18133-01
configuring for ML-100T-8 card 15-1 to 15-20
overview 15-1
selective autonegotiation 17-2
service-policy command, traffic policies 11-15
service-policy input command 11-16
service-policy output command 11-16
service-provider networks
and customer VLANs 8-2
and IEEE 802.1Q tunneling 8-1
Layer 2 protocols across 8-9
set cos command 11-15
setting
framing mode A-6
RPR wrap mode A-24
VCAT defect processing mode A-11
show bridge command 16-3
show controller pos command A-12
show interface pos command A-14
show interfaces bvi command 10-5
show interfaces irb command 10-5
show interfaces port-channel command 9-8
show ons alarm command A-15
show ons alarm defect command A-17
show ons alarm failure command A-19
show policy-map command 11-16
show sdm size command 12-3
show tech-support command C-2
show vlan command 7-5
SLA. See Cisco IOS, Cisco IP SLA
SNMP
CE-100T-8 card 17-6
ML-100T-8 card 1-5
soft reset on the ML-Series card 3-2
SONET alarms
CE-100T-8 card 17-11
configuring 5-6
configuring delay triggers 5-7
ML-100T-8 card support for 5-2
reported by the ML-100T-8 card 5-6
SONET circuits
CE-100T-8 card 17-6
in RPR 14-2
SONET ports, Enhanced State Model 17-4
Spanning Tree Protocol. See STP
SPR interface
assigning bridge group for RPR 14-13
assigning POS A-21
assigning POS ports to 14-11
configuring for RPR on ML-100T-8 card 14-9 to 14-11
spr-intf-id command A-21
spr load-balance command A-22
spr station-id command A-23
spr wrap command A-24
SSH
configuration guidelines 15-3
configuring 15-3
configuring server 15-4
displaying configuration and status 15-5
overview 15-2
setting up the ML-100T-8 card for 15-3
starting
ML-100T-8 card 3-5
RADIUS accounting 15-16
STP
See also BPDU
accelerated aging 6-9
blocking state 6-6
configuring 6-1 to 6-9, 6-15 to 6-20
configuring forward-delay time 6-20
configuring hello time 6-19
configuring maximum-aging time 6-20
configuring path cost 6-18
configuring port priority 6-17
configuring switch priority 6-18
configuring the root switch 6-17
creating topology 6-5
default configuration 6-16
disabled state 6-7