Cisco Systems 270 Switch User Manual


 
92
Power Supply page 98
Rack-Locator
Run Card Tests
References to “Cards” refers to fabric controllers, management I/O modules, node cards and the chassis
ID module. Fans and power supplies are not included in the Card tests; they can be tested through the
standard chassis test (page 95), or as individual components.
The following tests are available to locate and diagnose one or more cards in the chassis:
•LED
•Self-test page 92
Run a Card Self-Test
To perform a diagnostic self-test on a card:
1. Enter the diag card # command.
You cannot stop the card test once it has begun.
Example
2. Exit the test to view the progress of the test.
The test takes approximately 5 - 8 minutes.
Example of test in progress
SFS-270> enable
SFS-270# config
SFS-270(config)# diag card 11
SFS-270(config-diag-card-11)# test self-test
SFS-270(config-diag-card-11)# start
SFS-270(config-diag-card-11)# exit
SFS-270(config)# exit
SFS-270# show diagnostic card 11
================================================================================
Diagnostic Tests For Cards
================================================================================
test : self-test
slot-id : 11
iterations : 1
action : start
result : In progress
percentage-completed : 0
result-string :