Filter
Top Products
3-19
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Chapter 3 Installing the IP/TV Server
Installing Cisco IP/TV 3427 Broadcast Server Units
Step 5 Press the power control button on the front of the IP/TV Server.
The system should begin booting. Once the operating system boots, you are ready
to configure the IP/TV Server. (See Chapter 4, “Setting IP/TV Server
Configuration Parameters.”)
Note While the IP/TV Server is powering up, the green power on LED on the
front of the IP/TV Server is on.
Note You can install a circular disk over the power control button to prevent accidental
manual power down. This disk, known as the power control button shield, comes
with your IP/TV Server.
Installing Cisco IP/TV 3427 Broadcast Server Units
Place the unit in the desired location. You can mount it in a rack for your
convenience, or place it on a solid, stable surface. If you do not plan to install the
IP/TV Server in an equipment rack, proceed to the “Installing the IP/TV Server
on a Tabletop” section on page 3-30.
This section discusses the following topics:
• Rack Requirements
• Tools and Parts Required
• Installing the Chassis in the Rack
• Connecting Cables
• Connecting Power and Booting the System