Filter
Top Products
Chapter 3 Installing the IP/TV Server
Installing the IP/TV Server on a Tabletop
3-30
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Note You must connect a power cord to both power supplies. If only one power
supply is connected, when you turn on the power, the system error LED
comes on and the system makes a loud noise.
Step 3 Connect the other end of each power cord to a power source at your
installation site.
Step 4 Power up all externally connected devices.
Step 5 Press the power control button on the front of the IP/TV Server.
The system should begin booting. Once the operating system boots, you are ready
to configure the IP/TV Server. (See Chapter 4, “Setting IP/TV Server
Configuration Parameters.”)
Note While the IP/TV Server is powering up, the green power on LED on the
front of the IP/TV Server is on.
Installing the IP/TV Server on a Tabletop
When you install an IP/TV Server on a workbench or tabletop, ensure that the
surface is clean and in a safe location and that you have considered the following
points:
• The chassis should be installed off the floor. (Dust that accumulates on the
floor is drawn into the interior of the chassis by the cooling fans. Excessive
dust inside the IP/TV Server can cause overtemperature conditions and
component failures.)
• There must be approximately 19 inches (48.26 cm) of clearance at the front
and rear of the chassis for accessing network cables or equipment.
• The IP/TV Server must receive adequate ventilation (do not install it in an
enclosed cabinet where ventilation is inadequate).