Filter
Top Products
3-31
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Chapter 3 Installing the IP/TV Server
Connecting Cables to Video Capture Cards
To install the IP/TV Server on a workbench or tabletop, follow these steps:
Step 1 Remove any debris and dust from the tabletop or workbench, as well as from the
surrounding area. Also make sure that your path between the IP/TV Server and its
new location is unobstructed.
Step 2 Attach the rubber feet to the bottom of the chassis. The rubber feet have an
adhesive backing. Peel the protective tape off the adhesive and stick the feet to the
bottom of a clean chassis surface. Place one foot in each corner.
Step 3 Place the chassis on the tabletop or workbench.
Step 4 Ensure that no exhaust air from other equipment will be drawn into the chassis.
Also, ensure that there is adequate clearance at the front and rear of the chassis.
Connecting Cables to Video Capture Cards
This section explains how to connect the video capture cards in your IP/TV Server
to audio or video devices. The Cisco IP/TV 3426 Broadcast Server uses a Winnov
Videum 4400 AV video capture card, and the Cisco IP/TV 3427 Broadcast Server
is equipped with a combination of the following video capture cards:
• Winnov Videum 4400 AV
• Winnov Videum 1010 Plus
• Optibase MovieMaker 200S Networker
Winnov Videum 4400 AV Video Capture Card
The Winnov Videum 4400 AV video capture card has four audio and video capture
channels that can be connected to four independent audio and video sources.
The IP/TV Server accessory kit contains the following cables for connecting the
IP/TV Server to audio and video sources:
• Video BNC connector cables
• 4-channel audio connector cable with four stereo 1/4-inch mini-jacks using a
breakout cable