Filter
Top Products
2-16
Cisco ME 4924-10GE Ethernet Switch Hardware Installation Guide
OL-10071-01
Chapter 2 Switch Installation
Removing the 10-Gigabit Ethernet X2 Module
Removing the 10-Gigabit Ethernet X2 Module
Caution The 10-Gigabit Ethernet X2 module is a static-sensitive device. Always use an ESD wrist strap or similar
individual grounding device when handling modules or coming into contact with modules.
If you are removing a 10-Gigabit Ethernet X2 module, follow these steps:
Step 1 Disconnect the network fiber-optic cable from the module connectors. Immediately reinstall the dust
plugs in the module optical bores and the fiber-optic cable SC connectors.
Step 2 Grip the sides of the module sleeve with your thumb and forefinger, and pull the sleeve out to release the
module from the socket connector. (See Figure 2-11.)
Figure 2-11 Removing the 10-Gigabit Ethernet X2 Module
Step 3
Slide the 10-Gigabit Ethernet X2 module out of the socket and immediately place it in an antistatic bag.
Step 4 Reinstall the socket cover if you are not installing an X2 module in the empty socket.
a. Position the socket cover in front of the socket opening.
b. Snap the socket cover in place.
Module Maintenance Guidelines
To properly maintain X2 modules, follow these guidelines:
• To prevent ESD damage, follow normal handling procedures.
• When the module is stored or when a fiber-optic cable is not plugged in, always keep plugs in the
optical bores.
Cisco ME 4924-10GE
154918