Filter
Top Products
2-17
Cisco ME 4924-10GE Ethernet Switch Hardware Installation Guide
OL-10071-01
Chapter 2 Switch Installation
Cleaning the Fiber-Optic Connectors
• The most common source of contaminants in the optical bores is debris picked up on the ferrules of
the optical connectors. Use an alcohol swab or Kim-Wipe to clean the ferrules of the optical
connector.
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments.
Statement 1051
Cleaning the Fiber-Optic Connectors
In a fiber-optic system, light is transmitted through an extremely small fiber core, often 62.5 microns or
less in diameter. Because dust particles range from a tenth of a micron to several microns in diameter,
dust and any contamination at the end of the fiber core can degrade the performance of the connector
interface where the two cores meet. Therefore, the connector must be precisely aligned, and the
connector interface must be absolutely free of trapped foreign material.
Connector loss, or insertion loss, is a critical performance characteristic of a fiber-optic connector.
Return loss is also an important factor. Return loss specifies the amount of reflected light; the lower the
reflection, the better the connection. The best physical contact connectors have return losses greater than
–40 dB, although –20 to –30 dB is more common.
The connection quality depends on the type of connector and the proper cleaning and connection
techniques. Dirty fiber connectors are a common source of light loss. Keep the connectors clean at all
times, and keep the dust covers installed when the connectors are not in use.
Before installing any type of cable or connector, use a lint-free alcohol pad from a cleaning kit to clean
the ferrule, the protective white tube around the fiber, and the end-face surface of the fiber.
As a general rule, whenever there is a significant, unexplained loss of light, clean the connectors.
Caution Use extreme care when removing or installing connectors so that you do not damage the connector
housing or scratch the end-face surface of the fiber. Always install protective covers on unused or
disconnected components to prevent contamination. Always clean fiber connectors before installing
them.
To clean the optical connectors, use a CLETOP cassette cleaner (type A for SC connectors or type B for
MT-RJ connectors) and follow the product directions. If a CLETOP cassette cleaner is not available,
follow these steps:
Step 1 Use a lint-free tissue soaked in 99 percent pure isopropyl alcohol to gently wipe the faceplate. Wait five
seconds for the surfaces to dry, and repeat.
Step 2 Remove any residual dust from the faceplate with clean, dry, oil-free compressed air.
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments.
Statement 1051
Step 3 Use a magnifying glass or inspection microscope to inspect the ferrule at an angle. Do not look directly
into the aperture. Repeat the process if any contamination is detected.