Filter
Top Products
CHAPTER
Preparing for Installation 2-1
2
Preparing for Installation
This chapter describesthe general equipment, safety, and site preparationrequirements for installing
the PA-4T+ port adapter.
• Tools and Parts Required, page 2-1
• Software and Hardware Requirements, page 2-2
• Safety Guidelines, page 2-3
• FCC Class B Compliance, page 2-5
Tools and Parts Required
You need the following tools and parts to install a port adapter. If you need additional equipment,
contact a service representative for ordering information.
• PA-4T+(=) port adapter and one of the following:
— VIP2-15(=) if you are installing only one PA-4T+; otherwise, we recommend a VIP2-40(=)
or VIP2-50(=)
— Cisco 7200 series router with at least one available port adapter slot
— Cisco uBR7200 series router with at least one available port adapter slot
— Cisco 7100 series router with at least one available port adapter slot
• Serial cables appropriate for the desired port adapter interface types and the desired modes. (See
the “LEDs” section on page 1-15.)
• Number 1 Phillips and a 3/16-inch, flat-blade screwdriver.
• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.