Filter
Top Products
Configuring the PA-4T+ Interfaces 8-15
Using show Commands to Display Interface Information
Using show Commands to Display Interface Information
To display information about a specific interface, use the show interfaces command with the
interface type and portaddress in the format show interfaces [type slot/port] on a Cisco 7200 series,
Cisco uBR7200 series, or Cisco 7100 series router, or show interfaces [type slot/port-adapter/port]
on a VIP2.
Note Output from the show interfaces command displays the PA-4T+ as M4T.
Cisco 7200 Series, Cisco uBR7200 Series, and Cisco 7100 Series show interfaces Command
Following are examples of how the show interfaces [type slot/port] command on a Cisco 7200
series, Cisco 7100series or aCisco uBR7200 series routerdisplays status information(including the
physical slot and port address) for the interface you specify.The four PA-4T+ interfaces (0–3) are in
port adapter slot 1.
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]
Router# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.2
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]
Router# show interfaces serial 1/2
Serial1/2 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.3
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]
Router# show interfaces serial 1/3
Serial1/3 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.4
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]