Filter
Top Products
18
5 Connect the Management Interfaces and Perform Initial System
Configuration
This section explains how to connect the SCE 2000 platform to a local console and perform the initial system
configuration via the setup wizard that runs automatically.
Additionally, this section contains instructions for cabling the Fast Ethernet Management interface.
Note
When installing a cascaded system, it is extremely important to follow the sequence of procedures outlined in the section
Installing a Cascaded System (on page 56).
Connect the Local Console
Figure 12: Connecting to the Local Console
You must first connect the unit to a local console and configure the initial settings for the SCE 2000 to support remote
management. When the initial connection is established, the setup utility will run automatically, prompting you to perform
the initial system configuration.
Make sure that the terminal configuration is as follows:
• 9600 baud
• 8 data bits
• No Parity
• 1 stop bits
• No flow control