Filter
Top Products
9 Troubleshoot Startup Problems
SCE 2000 Operational Status
The following table lists the operational states of the SCE 2000. The Status LED on the SCE 2000 Front Panel reflects
the current SCE 2000 operational status. The operational status can be displayed using CLI command show system
operation-status.
Table 9-1 SCE 2000 Operational States
SCE 2000
Operational
Status
Description Status LED State
Booting Initial state after reset Orange
Operational SCE 2000 becomes operational after completing the following process:
• Boot is completed
• Power self-tests are completed without failure
• Platform configuration is applied
Flashing green
Warning SCE 2000 is fully operational (as above) but one of the following occurred:
• Line ports (FE ports) to the link are down
• Management port link is down
• Temperature raised above threshold
• Voltage not in required range
• FANs problem
• Power supply problem
• Insufficient space on the disk
Note: If the condition that caused the SCE 2000 to be in Warning state is
resolved (for example, link is up) the SCE 2000 reverts to Operational state.
Flashing orange
Failure System is in Failure state after Boot due to one of the following conditions:
• Power on test failure.
• Three abnormal reboots in less than 20 minutes
• Platform configured to enter Failure mode consequent to failure-induced
reboot (this is configurable using CLI command).
Note: Depending on the cause of failure, the management interface and the
platform configuration may or may not be active/available.
Red