Filter
Top Products
41
Connect the Management Interface
Figure 13: Cabling the Management Port
Note
By default, the management port is configured to auto-negotiation enabled.
The SCE 2000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.
Step 1 Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the
SCE 2000.
Step 2 Connect the other end of the Ethernet cable into your management network.
The Link LED on the SCE 2000 management port should light up.
Step 3
Test connectivity. From the host that you intend to use for remote management, ping to the SCE 2000 by typing
ping and the SCE 2000 IP address, and pressing Enter (see the example, below).
This verifies that an active connection exists between the specified station and the management port.