Filter
Top Products
59
To set the link mode:
Step 1 From the SCE 2000 (config if)# prompt, type link-mode [FE1-FE2/FE3-FE/ all-links]
[forwarding|bypass|sniffing|cutoff] and press Enter.
Monitoring the System
Use the following commands to view the current connection mode and link mode parameters.
To view the current connection mode:
Step 1 From the SCE 2000# prompt, type show interface linecard 0 connection-mode and press
Enter.
To view the current link mode:
Step 1 From the SCE 2000# prompt, type show interface linecard 0 link mode and press Enter.
To view the current link mappings:
Step 1 From the SCE 2000# prompt, type show interface linecard 0 physically-connected-
links and press Enter.