Filter
Top Products
8
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 129
Simple Network Management Protocol
This chapter describes how to configure the Simple Network Management
Protocol (SNMP) to perform configuration and statistics gathering tasks.
It contains these topics:
• General SNMP Settings
• Views
• Groups
• Users
• Targets
General SNMP Settings
You can use the General page to enable SNMP and configure basic protocol
settings.
To configure general SNMP settings:
STEP 1 Select SNMP > General in the navigation pane.
STEP 2 Select Enabled for the SNMP setting. SNMP is disabled by default.
STEP 3 Specify a UDP Port for SNMP traffic.
By default, an SNMP agent listens only to requests from port 161. However, you
can configure this so that the agent listens to requests on a different port. The valid
range is from 1025 to 65535.
STEP 4 Configure the SNMPv2 settings:
• Read-only Community—A read-only community name for SNMPv2
access. The valid range is 1 to 256 alphanumeric and special characters.